Booster Pump Water Pressure Tank Installation Diagram

A water pressure booster pulls water from the well water storage tank to pressurize the water in the house.

Booster pump water pressure tank installation diagram.

Install a pressure tank on the delivery side of the pump as shown in the diagram. Pump can be mounted to the wall horizontally in either direction or vertically only one way with pump head and. One side of the tank has pressurized air which pushes the water up and out of the tank into the plumbing system. This article describes the use of water pressure boosting systems that add a pump and pressure tank to improve water pressure and flow including improving water pressure flow on the upper floors of tall buildings.

The system must be protected by a suitable relief valve. Booster pump installation instructions 1. Pressure tank installation and operating instructions rules for safe operation this is a diaphragm type pressure tank for use on a cold well water system. A pressure booster system attaches to the main water line.

The transformer power cord. How why to choose install a water pressure booster pump. Technically qualified personnel should install pumps and motors. Pump must be located within 2 feet of pressure switch and within 6 feet of power outlet.

Drain valve drain easy draining of. Position the pump so that the inlet tube the 1 4 tube that supplies water to the ro unit can be routed through it. We recommend that a licensed contractor install all new systems and replace existing pumps and motors. Install pressure switch in tank line.

Open the ledge faucet and keep it open to relieve pressure. Taps are provided to accept pressure switch pressure gauge drain valve relief valve sniffer valve etc. A pressure switch turns on the pump which pushes the water through a tube into the tank. See diagram on back for where to place the pressure switch.

This brief article outlines the basic installation layout for water pressure booster pumps coupled with back up water tanks. A private well that does not produce enough water to keep up with demand requires a storage tank for the well to fill over time and a home booster pump from the tank to keep up with daily demand. Failure to install a relief valve may result in tank explosion in the event of a system. Turn off incoming water and ro storage tank valve.

Where possible we recommend the use of both water pressure booster pumps and water tank stands. Once this volume has built up then the pressure switch turns off and the water then pushes out into the line providing a more constant flow and pressure. Water tanks on tank stands ensure there is always some pressure available even in the event of a power failure. Installed near the tank inlet to hold water in the tank during pump installation when the pump is idle.

The pressure shutoff switch.