Bottom Nailling Strip For Wood Siding Shingles

Fasten a cedar starter strip the same thickness as the top of the beveled siding all around the house using a tape measure and level to set it level along the bottom of the wall.

Bottom nailling strip for wood siding shingles.

It is used behind siding and trim pieces to protect the backerboard. If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this. Apply siding to wall assembly directly to wood structural panel sheathing. Wood siding shingles and shakes.

Click to enlarge any image this article series discussion includes wood shingle siding underlayment requirements. When nailing shingles proper penetration into the roof deck is essential to ensure the nail and shingle remain secure. Siding nail face nailing face nailing is applicable where dictated by building code in high wind areas and when fastening is to osb or equivalent sheathing without penetrating into studs. Begin by nailing a starter strip approximately 3 8 inch thick x 1 1 2 inch wide flush with bottom edge of sill plate.

Starting from left to right level and install the siding so the bottom edge is no more than 1 2 inch below the starter strip. Starter strip should be 4 5 in. If desired the starter strip can be cut from the top of the siding and the bottom portion used for the top course. The indentations profile cut outs of the bottom edge of the first course of siding must overlap.

This is a decorative feature that covers the top of the siding where it connects to the soffit. Put the bottom step flashing on the starter course then bend the bottom of the step flashing out about 1 to 1 away from the wall. For all owens corning shingles roofing nails should penetrate into the wood deck by a minimum of inch or completely through the roof deck by a minimum of 1 8 inch. Wood shingle siding nailing details.

Install the kickout flashing underneath the first shingle photo 1. Thick and installed to hang below shim approximately 1 in. This strip of wood or metal is attached to brick stucco or old siding. You do have to trim the top starter course shingle with a triangle shaped cut to allow this.

The difference between a good shingle and a great shingle is having surenail technology only available from owens corning on duration series shingles. The top of the step flashing is still under the siding or plaster. Adapted paraphrased with permission from best practices guide to residential construction.